Resinex, Member of the Ravago Group
Saturday, October 19, 2019
Braskem PE SLL318
Units 
Braskem - Linear Low Density Polyethylene
ActionLegend (Open)
E-Mail a Datasheet Print this Page  

General Information
Product Description
SLL318 is a Linear Low Density Polyethylene developed for cast film extrusion. Films obtained with this product show good mechanical properties and enhanced sealability. It contains antioxidant additives. The minimum biobased content of this grade is 87%, determined according to ASTM D6866.

Applications:
Stretch films; liners; LDPE and HDPE blends and packages for general use.
Others applications: blends for irrigation pipes; insulation for low and medium tension XLPE wires
and cables.

Process:
Recommended processing conditions for film extrusion about 170 - 210 °C. The optimum processing conditions will vary according to the type of equipment used and cannot be considered as performance guarantee.
General  
Material Status 
  • Commercial: Active
Availability 
  • Europe
  • Latin America
  
Additive 
  • Antioxidant
Features 
  • Antioxidant
  • Renewable Resource Content
  
Uses 
  • Blending
  • Cast Film
  • Film
  • Liners
  • Packaging
  • Piping
  • Stretch Wrap
  • Wire & Cable Applications
Agency Ratings 
  • FDA 21 CFR 177.1520
Processing Method 
  • Cast Film
  • Film Extrusion
  
ASTM & ISO Properties 1
Physical
Nominal Value
Unit
Test Method
Density
0.918
g/cm³
 ASTM D1505
Melt Mass-Flow Rate (MFR) (190°C/2.16 kg)
2.7
g/10 min
 ASTM D1238
Biobased Content
87
%
 ASTM D6866
Films
Nominal Value
Unit
Test Method
Tensile Strength - MD (Break, 38 µm, Blown Film)
30.0
MPa
 ASTM D882
Tensile Strength - TD (Break, 38 µm, Blown Film)
30.0
MPa
 ASTM D882
Tensile Elongation - MD (Break, 38 µm, Blown Film)
1200
%
 ASTM D882
Tensile Elongation - TD (Break, 38 µm, Blown Film)
1400
%
 ASTM D882
Flexural Modulus - 1% Secant, MD (38 µm, Blown Film)
180
MPa
 ASTM D790
Flexural Modulus - 1% Secant, TD (38 µm, Blown Film)
200
MPa
 ASTM D790
Dart Drop Impact (38 µm, Blown Film)
90
g
 ASTM D1709
Elmendorf Tear Strength - MD (38 µm, Blown Film)
120
g
 ASTM D1922
Elmendorf Tear Strength - TD (38 µm, Blown Film)
340
g
 ASTM D1922
Notes
1Typical properties: these are not to be construed as specifications.
 
Customer is responsible for determining whether products and the information in this document are appropriate for Customer’s use and for ensuring that Customer’s workplace and disposal practices are in compliance with applicable laws and other governmental enactments. Seller assumes no obligation or liability for the information in this document. NO WARRANTIES ARE GIVEN; ALL IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE ARE EXPRESSLY EXCLUDED.